Hollow Point: Bullets of this size tend to get stuck in the body. Second Media Corp., 111 Peter Street, Suite 600, Toronto, Ontario, M5V 2H1, Canada. Upon firing the second round the gun "blew up." "The fear of death follows from the fear of life. A forum community dedicated to Rimfire Central Firearm owners and enthusiasts. Or did the second round cause more damage because the block was weakened? Good thing, since I can't get enough of the spring rod visible to get a wrench on anyway. With the safety on the it will slightly slide back (normal) but when the safety is off it will slide back twice as far and stop. Pull the slide cover offremove firing pinthat will ensure when you pound it back, it will not detonate, Use a nylon or wooden dowel, tap it out with a hammer. Revolver: This type of handgun doesn't throw away the empty shells when the bullet is fired. 4. 25 votes, 51 comments. Of course that huge flat front surface means those bullets slow down way, WAY faster than Spitzer (pointed) bullets. It looked like the shells didn't get resized properly. The theory there is that a liquid with minimal surface tension will conform to whatever shape is the most aerodynamic by the simple fact that it doesnt have the structural rigidity required to resist the most aerodynamic shape. bullet stuck in chamber backwards - creditsolutionexperts.com try mortaring the stock, smack it on the ground while holding the charging handle and yank it backwards. He then took a large hammer and struck the end of the rod to begin driving the bullet out the muzzle. If the bullet sets back in the case. high vels are fine , though. Agreed, It sounded like you thought I was against wadcutters, not at all. That's much more preferred than slamming the back of the gun with my fist, for sure. Screaming with rage and frothing at the mouth it stuck wildly with its heavy claws, but Tanar . How to Remove a Stuck Bullet! Yes it may work (and you may live to tell about it) but your banging on the front of a live round. How to remove bullet lodged in barrel? - The Firing Line Forums 8. Thanks for the tip! Always load bullets with the base of the bullet facing the primer. I say put it back on the frame, put on your big boy pants, grip the hell out of the slide with one hand while you slam the rear of the grip with your other palm.