I entered sensor code and then entered transmitter code as it prompted me. I just restarted my G6 tonight. Once it reconnected the Dexcom ap screen on my phone said that I still had 15 minutes left in the warmup period and continued to function normally. Dexcom, Dexcom Follow, Dexcom Clarity, and Dexcom Share are registered trademarks of Dexcom, Inc. in the U.S., and may be registered in other countries. If required, enter the calibrations in both the phone and receiver at the same time. So I messed up the timing to restart my sensor before it told me it was time. Then restart the same sensor as if it was new . When I used this method *before* the sensor session ended, it worked perfectly fine. I followed the first step and erased the Dexcom Bluetooth info. I managed to do it with a simple tool by myself with the sensor on my arm (see video below), so its not impossible. To do this:-. But, not many people have two transmitters going to do that process at any one time. Then waited about 15 min or so then did new sensor on iPhone. I was able to pry the transmitter out and restart the sensor on my daughter! You can change a Dexcom G6 sensor earlier than 10 days. awesomeim sure its just a matter of playing around with a bit more like you say. From the Home Screen, tap OPTIONS. This process is not working for me. Another other thoughts on how to avoid my phone resetting as well as the receiver? It worked!! During this 2+ hours of waiting, the receiver will have signal loss and no data message. After that you will get calibration notices. Come back to these directions when you simply need to extend that 112 days. Unfortunately, today, after the receiver synced up with the transmitter, it gave me the No Restarts error and now the phone app is also giving its own version of the No Restarts error. The session will end on its own to the exact hour and minute that the start sensor option was selected 10 days prior. 3. I just did another restart and no calibration requests were required. I stopped the sensor before I did the forget Dexcom step in the bluetooth settings. The transmitter, holder, and sensor all come off with the patch. Pairing a new transmitter using your receiver. Did you stop sensor on the T-Slim as well as the phone? You can choose to ignore them or notthe session will keep going. You can use a test strip to dislodge the transmitter and then wait 20 minutes so the transmitter thinks it's being changed. Without insurance $4914$264.14 90-day supply with manufacturer coupon. Not sure how I did this, but I was able to reset my sensor *after* the 2 hour alert. If you dont see Pair new transmitter, you must select Stop Sensor first, Then follow the on-screen prompts to pair your new transmitter. I did get everything working together again, several sensor fails, which only took 4-5 (wasted, had to do finger sticks ) CGM hours! Id previously used Option 1 with success, which is nice since you dont lose the 2 hours. Shame, I was hoping they would last as long as G5 on me, 21 to 28 days! In step 9 of method 1, after I allow the receiver to connect to the transmitter, the No Data message does go away, but it is replaced with a Start Sensor message. Where does the waiting two hours come from?